10:25 AM , Posted in Pattern-its types and its allowances
“Pattern”- making, allowances and its types:
A pattern may be defined as a model of desired casting which when moulded in sand forms an impression called mould. The mould when filled with the molten metal forms casting after solidification of the poured metal. The quality and accuracy of casting depends upon the pattern making. The pattern may be made of wood, metal(cast iron, brass, aluminium and alloy steel.), plaster, plastics and wax.
A pattern is always made larger than the required size of the casting considering the various allowances. These are the allowances which are usually provided in a pattern.
1: shrinkage or contraction allowance:
The various metals used for casting contract after solidification in the mould. Since the contraction is different for different materials, therefore it will also differ with the form or type of metal.
2: Draft allowance
It is a taper which is given to all the vertical walls of the pattern for easy and clean withdraw of the pattern from the sand without damaging the mould cavity. It may be expressed in millimeters on a side or in degrees. The amount of taper varies with the type of patterns. The wooden patterns require more taper than metal patterns because of the greater frictional resistance of the wooden surfaces.
3: Finish or machining allowance
The allowance is provided on the pattern if the casting is to be machined. This allowance is given in addition to shrinkage allowance. The amount of this allowance varies from 1.6 to 12.5 mm which depends upon the type of the casting metal, size and the shape of the casting. The ferrous metals require more machining allowance than non ferrous metals.
4: Distortion or camber allowance
This allowance is provided on patterns used for casting of such design in which the contraction is not uniform throughout.
5: Rapping or shaking allowance
This allowance is provided in the pattern to compensate for the rapping of mould because the pattern is to be rapped before removing it from the mould.
Types of Patterns:
The common types of patterns are as follows:
1. solid or single piece patterns
2. split or two/multiple piece patterns
3. match plate pattern
4. cope and drag pattern
5. loose piece pattern
6. gated patterns
7. sweep pattern
8. skeleton pattern
9. shell pattern
10. segmental pattern
11. follow board pattern
12. lagged up pattern
13. left and right hand pattern